HTA1000 Waterbased (Heat activated) contact adhesive
ONE PART WATER-BASED ADHESIVE FOR HIGH TEMPERATURE APPLICATIONS
PRODUCT INFORMATION
HTA1000WB is a single component sprayable adhesive that provides instant grab and high heat resistant bonding. HTA1000WB is sprayable through air assisted equipment free of copper & brass.
For best results or large production runs we advise using a pressurised spray / pot system.
For smaller areas and for trials a gravity fed spray gun with a stainless steel nozzle and 1.4- 2.0 needle. We can supply either set up.
It is based on novel water-based dispersion technology that is safe to use. It contains no solvents or isocyanates and conforms to the latest environmental legislation.
HTA1000WB can be used on a variety of substrates to give instant bonds characterised by high strength once fully cured. HTAWB- Can be applied to a surface and left to cure, when required this at a later date can be reactivated by the introduction of heat.
KEY INFORMATION
Water-based adhesive – safe to use and environmentally friendly
Instant hold
HEAT REACTIVE TECHNOLOGY
Ideal for applications involving porous substrates
Heat resistance up to 140°C
Cold resistance down to -40°C
Good adhesion when bonding porous materials to non-porous substrates
TYPICAL APPLICATIONS
Automotive industry for the production of trim application such as car panels, seats, headrests and headliners.
Marine industry for trimming applications on a wide variety of fabrics to wood, metal and composite materials.
Bonding foam-based insulation panels to plasterboard.
It can also be used as a general purpose adhesive where high temperature resistance is a preference.